Primers & Fittings

The 1/4" Quick Disconnect / Fuel Restrictor can be used as fuel line quick disconnect and/or for fuel restriction. Pre-tapped and threaded to accept Mikuni Main Jet (Jets not included). Includes stainless steel hose clamps. Now Available in all colors!

Finish the look of your engine compartment with Blowsion specialty colored 1/4" fuel hose. Available in Clear, Blue, Green, Orange, Red, Yellow, or Black. Quantity is sold by the foot in continuous lengths.

Finish the look of your engine compartment with Blowsion specialty colored 1/8" fuel primer hose. Available in Clear, Blue, Green, Orange, Red, Yellow, or Black. Quantity is sold by the foot.

Blowsion Fuel Tank Fitting with Rubber Grommet. 1/4 Hose Barb. Compression Fit. Install with 17/32 Drill Bit.

Part Number: 01-02-598

Universal Fuel Pickup Filter. Add some of these for extra fuel filtration and also keeps the fuel in your lines when going upside down.

Part Number: 01-02-449

Oil block-off plates allow for an easy conversion from factory oil injection to pre-mixing your own fuel. Block-off plates fit all Yamaha 650701/760 and Kawasaki 650/750 Models. Hardware included. Anodized Black.

Part Number: 01-03-812

Try the sanitary "non foot destroying" rubber-based bulb type primer. In stock and ready to flow! Pair with the Blowsion Dash Fitting for best protection.

Part Number: 01-02-411

Fits 6mm choke shaft Mikuni dual carburetors. Starting the engine of your personal watercraft is never a problem with a Blowsion primer kit. All brass fittings and Primer Bulb. Get rid of that worthless factory choke and apply a direct shot of fuel! Pair with the Blowsion Dash Fitting for best protection.

Part Number: 01-02-406

Fits 6mm choke shaft Mikuni single carburetor. Starting the engine of your personal watercraft is never a problem with a Blowsion primer kit. All brass fittings and Primer Bulb. Get rid of that worthless factory choke and apply a direct shot of fuel! Pair with the Blowsion Dash Fitting for best protection.

Part Number: 01-02-405

Fits 6mm choke shaft Mikuni dual carburetors. Starting the engine of your personal watercraft is never a problem with a Blowsion primer kit. All brass fittings and bulletproof plunger.

Part Number: 01-02-402

Fits 6mm choke shaft Mikuni single carburetor. Starting the engine of your personal watercraft is never a problem with a Blowsion primer kit.

Part Number: 01-02-401

The tried-and-true plunger style primer. In stock and ready to flow!

Part Number: 01-02-410

Brass Press In Straight Pulse Line Nipple Fitting 1/4" Hose Barb. Use for dual carburetor setups with dual fuel pumps where a second pulse line is required.

Part Number: 01-02-530

6mm Brass Push-In Primer Barb Fitting for Mikuni Carburetors.

Part Number: 09-02-407