Engine Performance
-
Primer Kit - Keihin Single
Fits 8mm choke shaft Keihin single carburetors. Starting the engine of your personal watercraft is never a problem with a Blowsion primer kit. All brass fittings and bulletproof plunger. Get rid of that worthless factory choke and apply a direct shot of fuel!
Part Number: 01-02-403
Learn More -
MSD Spark Plug Boot Retainers
MSD Spark Plug Boot Retainer Secures the boot to the base of the spark plug.
Part Number: 01-05-605
Learn More -
MSD Single Tower Isolated Coil
PWC Specific Model MSD Coil. Single Tower, Isolated Ground. Specially Designed w/ higher turns ratio. Resulting in a tighter voltage spark. For MSD Total Loss Ignitions.
Part Number: 01-05-011
Learn More -
MSD Salt Water Spark Plug Boot Kit
This is THE ANSWER for riders dealing with erratic spark caused by corrosion and exposure to saltwater. Kit includes instructions, two MSD 90-degree boots, MSD plug cap retainers, two crimp-on terminals, vulcanizing tape, and dielectric compound.
Part Number: 01-04-411
Learn More -
MSD Mini Stripper / Crimper
MSD Mini Stripper Spark Plug Wire 8.5mm. Designed to be used in a vise and with a single-edge razor blade to strip spark plug wires without damaging the core and to crimp a terminal.
Part Number: 01-04-422
Learn More -
MSD Improved Stock Coil
More juice for your powerplant than any OEM coil can provide. New Updated model! Fits all years Yamaha Superjet 650/701/760, and Kawasaki 750 and 800 SXR.
Part Number: 01-05-012
Learn More -
FP Headpipe Water Screw Kit - Standard
Blowsion standard size stainless headpipe screw kits. Replace those always corroded and plugged FP water adjusting screws!
Part Number: 01-01-740
Learn More -
FP Headpipe Water Screw Kit - Oversized
Blowsion Oversized Factory Pipe Headpipe Screw Kit. Drill out and replace your corroded and plugged water adjusting screws. Compatible with all Factory Headpipes
Part Number: 01-01-742
Learn More -
Billet Carburetor Block Off
Sanitary anodized and engraved Blowsion logo carburetor block off. A necessity when using a remote fuel pump. Fits all Mikuni carbs. Billet aluminum with all stainless hardware included.
Part Number: 01-02-557
Learn More -
Blowsion Battery Box
Replace that cracked and worn out stock plastic battery box with bulletproof Blowsion aluminum. Each box includes all stock location retaining clips for easy exchange. Padded bottom. Direct fit replacement for all years Yamaha Super Jet, FX1 and Polaris Octane. Can be fit as replacement to all Years Kawasaki 750 and SXR 800 with minor battery strap modifications. Color: Anodized Black
Part Number: 01-04-601
Learn More -
Ballistic Digital Battery Charger
The Ballistic Performance Components EVO2 Battery Management System Balance Charger is the only charger on the market designed specifically to work with the Ballistic Performance Components EVO2 battery. Available in 240V Euro Model Only.
Learn More -
Ballistic Battery Foam Spacer
Properly install and secure your ballistic battery with this foam spacer. Available for all size batteries.
Part Number: 01-04-627
Learn More -
Blowsion Side Exhaust Outlet - Kawasaki
Sanitize the outside of any standup exhaust outlet. Available in flush mount design for all Kawasaki's. Not a welded piece of aluminum but a true cast and coated work of art! All stainless mounting hardware included.
Part Number: 01-01-505
Learn More -
Factory Pipe - Dry Pipe O-Ring Kit
Replacement O-Ring kit fits Kawasaki 750/800/SXR Dry Pipes and Yamaha Type 4, FP Dry Pipe O-ring Kit (3-pieces).
Part Number: 01-01-710
Learn More -
OEM Pro Honda Dielectric Grease
Put this 0.5 ounce tube of miracle gel in your toolbox! This is the cure for for scattered spark resulting form moisture and corrosion of your spark plug ends and boots.
Part Number: 08798-0001
Learn More