Intake
-
Blowsion Colored Hose - 1/8 inch
Finish the look of your engine compartment with Blowsion specialty colored 1/8" fuel primer hose. Available in Clear, Blue, Green, Orange, Red, Yellow, or Black. Quantity is sold by the foot.
Learn More -
Mikuni Adjusting T Screws - Yamaha
Mikuni high and low-speed adjuster screws with "T" cross bar - extended length for easy adjustment. Absolutely a must when running aftermarket pipes. Fits all 1996-2020 Yamaha Superjet OEM 38mm Mikuni Carburetors.
Part Number: 01-02-544
Learn More -
Throttle Cable Drum
Billet aluminum throttle drum for maximum throttle adjustments. Machined from 6061-T6 aluminum and anodized for corrosion protection. Features 9 different hole locations for the throttle cable to attach. Now available in 5 different colors!
Learn More -
1/4" Quick Disconnect / Fuel Restrictor
The 1/4" Quick Disconnect / Fuel Restrictor can be used as fuel line quick disconnect and/or for fuel restriction. Pre-tapped and threaded to accept Mikuni Main Jet (Jets not included). Includes stainless steel hose clamps. Now Available in all colors!
Learn More -
Primer Bulb
Try the sanitary "non foot destroying" rubber-based bulb type primer. In stock and ready to flow! Pair with the Blowsion Dash Fitting for best protection.
Part Number: 01-02-411
Learn More -
Carburetor Adapter - Mikuni 38mm (3-Bolt)
Billet carb adaptors in stock and available to fit OEM Yamaha Superjet 38mm Mikuni carbs. Required for adapting to aftermarket air filters / flame arrestors. Sold Individually. Flange Outer Diameter: 2.75 (inches).
Part Number: 01-02-074
Learn More -
ADA Angled Reed Spacer - Yamaha 701/760
ADA Racing Yamaha 701/760 angled reed spacer kit. This will increase the case volume and direct the intake flow upward towards the transfer ports, resulting in improved power throughout. Includes billet reed spacer, gasket, and hardware.
Part Number: 34-130390
Learn More -
Keihin Carb Rebuild Kit 38-44MM CDK-II
Aftermarket Keihin Carburetor Rebuild Kit for 38mm, 40mm, 42mm and 44mm CDK-II Carburetors. Fits wide range of 38-44mm Keihin™ CDK-II carbs found on PWC. Includes Viton™ tipped inlet needle.
Part Number: 01-02-492
Learn More