Search results for 'Fx1'

Finish the look of your engine compartment with Blowsion specialty colored 1/4" fuel hose. Available in Clear, Blue, Green, Orange, Red, Yellow, or Black. Quantity is sold by the foot in continuous lengths.

Finish the look of your engine compartment with Blowsion specialty colored 3/8" water cooling hose. Available in Clear, Blue, Green, Orange, Red, Yellow, or Black. Quantity is sold by the foot in continuous lengths.

Inexpensive traction option. Gain control of your ski or runabout by applying these lifter wedges to your tray sides or inner and outer gunnels. Available in two length options. Sold as Pair (2). Color: Black

48" x 17.5" section of 18mm thick plush (softer) foam undermat. This our softest underpad. PLUSH offers greater comfort and compression recovery for extreme riders.

Part Number: 04-02-331

The ODI Cross Trainer 130mm Lock-On Grip Set features soft comfortable rib patterns interlaced with a thicker criss-cross pattern for a soft feel without a loss in control. Made in the USA!

Part Number: 03-05-370

Dual Color Sheets of 1/4" (5.5mm) Hydro-Turf with Cut Diamond Grooves. Available in any two of the color combinations Hydro Turf offers on the below drop down menus.

See our special formulated solvent-based Mat Glue for Installation.

Inline Water Filter. Made from impact resistant nylon with 3/8” barb ends. A clear bowl and removable filter screen allow easy inspection and cleaning.

Part Number: 01-01-780

Blowsion Fuel Tank Fitting with Rubber Grommet. 1/4 Hose Barb. Compression Fit. Install with 17/32 Drill Bit.

Part Number: 01-02-598

New! Blowsion Recessed Dash Mount. Fed up of breaking expensive Bilge Switches and Primer Bulbs? The Blowsion Team has a solution. The Recessed Dash Mount is perfect for mounting your switches and primers. The Mount enables the switch/primer to sit flush eliminating the risk of being knocked off. On top of that each mount comes with a Brushed Aluminum Anodized Bezel available in 5 color options. Stainless Steel Mounting Hardware and Installation Instructions Included.

Billet aluminum throttle drum for maximum throttle adjustments. Machined from 6061-T6 aluminum and anodized for corrosion protection. Features 9 different hole locations for the throttle cable to attach. Now available in 5 different colors!

Heavy Duty Stainless Steel Hose Clamp. Compatible with all 2.0" to 2.75" Inch (OD) Exhaust Couplers. Sold Each.

Part Number: 01-01-176

Blowsion Adjustable T-Handle Factory Pipe Headpipe Water Screw Kit - Standard Size. T-Handle Design provides quick and easy adjustments for tuning. This kit is a direct replacement for those seized up water adjusting screws. Compatible with all Factory Headpipes.

Part Number: 01-01-741

RRP Rickter Throttle Lever. Available in Black, Red, Blue or Silver.

RRP Rickter Trim Lever. Available in Black, Blue, Red or Silver.

Rule 25SA Fully Submersible Bilge Pump, 500 Gallon Per Hour, 12 Volt DC, Automatic Electronic Sensing. Bilge Pump turns on and checks for water approximately every 2-1/2 minutes. If resistance (water) is found, it will run for as long as water is present. When all the water is pumped out, the pump shuts off and returns to its 2-1/2 minute test cycle.

Part Number: 06-01-002