Search results for 'mikuni'

Sanitary anodized and engraved Blowsion logo carburetor block off. A necessity when using a remote fuel pump. Fits all Mikuni carbs. Billet aluminum with all stainless hardware included.

Part Number: 01-02-557

Mikuni high and low-speed adjuster screws with "T" cross bar - extended length for easy adjustment. Absolutely a must when running aftermarket pipes. Fits all 1996-2020 Yamaha Superjet OEM 38mm Mikuni Carburetors.

Part Number: 01-02-544

Mikuni Diaphragm Mount throttle cable bracket. Trick mounting setups are enabled with this handy bracket. Stainless Steel Mounting Hardware Included. Now available in two sizes.

Fits 6mm choke shaft Mikuni dual carburetors. Starting the engine of your personal watercraft is never a problem with a Blowsion primer kit. All brass fittings and bulletproof plunger.

Part Number: 01-02-402

Fits 6mm choke shaft Mikuni single carburetor. Starting the engine of your personal watercraft is never a problem with a Blowsion primer kit.

Part Number: 01-02-401

Billet carb adaptors in stock and available to fit OEM Yamaha Superjet 38mm Mikuni carbs. Required for adapting to aftermarket air filters / flame arrestors. Sold Individually. Flange Outer Diameter: 2.75 (inches).

Part Number: 01-02-074

Blowsion Exhaust Water Injector Brass Fitting. Tapped and threaded for a Mikuni Main Jet. 1/4" Hose Barb x 1/8" NPT. Bidirectionally slotted for better cooling. Used on aftermarket high performance exhaust systems (TNT/Powerfactor/RRP).

Part Number: 01-01-075

Dual Mikuni 46mm SBN Carburetor Kit. Linked and Custom Jetted to your engine specification. Available in 5 color options!

Dual Mikuni 44mm SBN Carburetor Kit. Linked and Custom Jetted to your engine specification. Available in 5 color options!

The 1/4" Quick Disconnect / Fuel Restrictor can be used as fuel line quick disconnect and/or for fuel restriction. Pre-tapped and threaded to accept Mikuni Main Jet (Jets not included). Includes stainless steel hose clamps. Now Available in all colors!

6mm Brass Push-In Primer Plug Fitting for Mikuni Carburetors.

Part Number: 09-02-409

6mm Brass Push-In Primer Barb Fitting for Mikuni Carburetors.

Part Number: 09-02-407

Fits 6mm choke shaft Mikuni single carburetor. Starting the engine of your personal watercraft is never a problem with a Blowsion primer kit. All brass fittings and Primer Bulb. Get rid of that worthless factory choke and apply a direct shot of fuel! Pair with the Blowsion Dash Fitting for best protection.

Part Number: 01-02-405

Fits 6mm choke shaft Mikuni dual carburetors. Starting the engine of your personal watercraft is never a problem with a Blowsion primer kit. All brass fittings and Primer Bulb. Get rid of that worthless factory choke and apply a direct shot of fuel! Pair with the Blowsion Dash Fitting for best protection.

Part Number: 01-02-406