Search results for 'WaveBlaster'

Allows air to flow in one direction. 1/4" Barbed ends. Available in clear/black only.

Part Number: 01-02-554

Get rid of that unsightly gauge window on the side of your Blaster with this sano billet piece. Installs with the OEM mounting hardware. Fits all years Yamaha WaveBlaster.

Part Number: 05-04-450

Blowsion Billet aluminum handle bar clamps for 7/8" Inch bars. Sold as a pair (2) with stainless bar clamp screws included. These bar clamps provide the finishing touch to a clean steering system. Now available in all anodized colors!

Direct water and air to where you want it in the engine compartment! Drop Tube and Urethane Flange for Hood Baffle Air Intakes. Use with either aftermarket hoods or stock factory hood to increase air flow. Each kit includes three oversize lengths of hose tubing and urethane flanges. Bond-able to hand laid fiberglass, carbon, SMC or ABS inner liners these are simple to install and are an excellent answer for air-starved motors. An EXCELLENT choice for the Kawasaki SXR 800 with the Factory Pipe installed!

Part Number: 05-02-199

Each kit includes all materials needed for mixing into, and handling, your installation resin (available separately). Silica Thickener, Mixing Cups, Brushes, Gloves and Knitted fabric cloth for all seams.

Part Number: 06-03-113

The key to installing Tubbie Sponsons, Railcaps and other composite accessories on your watercraft. Easy-to-use tube fits a standard caulking gun. Fast-set formula dries tack-free in 90 minutes and delivers extremely tough bonds. Color: Black.

Part Number: 06-03-136

The key to installing Tubbie Sponsons, Railcaps and other composite accessories on your watercraft. Easy-to-use tube fits a standard caulking gun. Fast-set formula dries tack-free in 90 minutes and delivers extremely tough bonds. Color: White.

Part Number: 06-03-135

Blowsion Mat Kit Glue "Blow Goo" to the rescue. Use this solvent-based contact adhesive with your Hydro Turf or stitched mat kit and never worry again about your mats coming loose. Not water-based!

Part Number: 06-03-141

Blowsion Mat Kit Glue "Blow Goo" to the rescue. Use this solvent-based contact adhesive with your Hydro Turf or stitched mat kit and never worry again about your mats coming loose. Not water-based!

Part Number: 06-03-142

Mikuni Diaphragm Mount throttle cable bracket. Trick mounting setups are enabled with this handy bracket. Stainless Steel Mounting Hardware Included. Now available in two sizes.

ODI Grip Blowsion Logo Lock Ring End Cap Combo- now you can have the anodized bling look all the way through to the end cap. Each kit includes inner lock rings, and outer lock ring/caps w/ hardware.

Oil block-off plates allow for an easy conversion from factory oil injection to pre-mixing your own fuel. Block-off plates fit all Yamaha 650701/760 and Kawasaki 650/750 Models. Hardware included. Anodized Black.

Part Number: 01-03-812

Fits 6mm choke shaft Mikuni dual carburetors. Starting the engine of your personal watercraft is never a problem with a Blowsion primer kit. All brass fittings and bulletproof plunger.

Part Number: 01-02-402

Fits 6mm choke shaft Mikuni single carburetor. Starting the engine of your personal watercraft is never a problem with a Blowsion primer kit.

Part Number: 01-02-401

Try the sanitary "non foot destroying" rubber-based bulb type primer. In stock and ready to flow! Pair with the Blowsion Dash Fitting for best protection.

Part Number: 01-02-411