Search results for 'WaveBlaster'

Properly install and secure your ballistic battery with this foam spacer. Available for all size batteries.

Part Number: 01-04-627

The Ballistic Performance Components EVO2 Battery Management System Balance Charger is the only charger on the market designed specifically to work with the Ballistic Performance Components EVO2 battery. Available in 240V Euro Model Only.

Blowsion 45-Degree machined aluminum bilge fittings are a clean replacement of the bulky plastic fittings usually supplied with aftermarket bilge pump kits. Available in Anodized Black or Clear.

Blowsion machined aluminum straight bilge fittings are a clean replacement of the bulky plastic fittings usually supplied with aftermarket bilge pump kits. Available in Clear, Black, Green, Red, Blue & Orange anodized colors.

Rule Non-Automatic 500GPH Fully Submersible 12 Volt DC bilge pump. Unmatched in pumping power and longevity. Higher Flow – optimized impeller to provide greater flow at the same amperage. Back Flow Prevention - reduces the amount of water left over in the bilge, reducing odor and helping keep your bilge cleaner. Easy to mount and ready to go!

Part Number: 06-01-001

Blowsion Bilge Pump Hose - 10 Foot Section is plenty for most dual pump and custom applications. Color: Black Only. Hose Diameter (ID): 3/4" inch.

Part Number: 06-01-302

Blowsion Bilge Pump Hose - 3 Foot Section is plenty for most single pump applications. Color: Black Only. Hose Diameter (ID): 3/4" inch.

Part Number: 06-01-301

Replacement Fuel Resistant Rule Bilge Pump Strainer Base. Compatible with All Rule 360-1100GPH Models.

Part Number: 06-01-311

Finally- a replacement switch and 9 feet of cable for the always popular handlebar mount switches.

Part Number: 06-01-215

Universal Handle Bar Mount Bilge Switch. Fits any watercraft handle bars on the market. Anodized Black.

Part Number: 06-01-212

Sanitary anodized and engraved Blowsion logo carburetor block off. A necessity when using a remote fuel pump. Fits all Mikuni carbs. Billet aluminum with all stainless hardware included.

Part Number: 01-02-557

Machined with the stand-up rider comfort at a premium, our new Blowsion straight pull finger throttles are ergonomically designed for premium fit and feel whether you are on the waves or on the buoys. Available in all colors!

Available for riders wanting to use the end flange only for custom scupper and rear exhaust installations etc. The new billet flange assembly is the premium design setup and allows use of the Blowsion billet exhaust outlet so vain riders can sanitize both sides of the rear of their watercraft. Fits all years Super Jet, KAWI 750 and SXR 800, KAWI 650, and Polaris Octane. Anodized Clear.

Part Number: 06-01-023

Blowsion Cross Bar Pad. For use with all 7/8" inch Standup and Sport watercraft handlebars including Blowsion Kommand Bars. Pad measures 5.25 inches in length. Available in all colors!

Blowsion Handlebar Extensions. Add up to an additional 2 inches to your bars. Trim lines available for custom length options.

Part Number: 03-05-139