Search results for 'Fuel'

Introducing the new Blowsion Yamaha Fuel Pickup. Designed with the option for use as a single, dual and triple pickup this billet beauty is the lowest profile and lightest weight internal fuel filler available.

Replacement Fuel Resistant Rule Bilge Pump Strainer Base. Compatible with All Rule 360-1100GPH Models.

Part Number: 06-01-311

Sanitary anodized and engraved Blowsion logo carburetor block off. A necessity when using a remote fuel pump. Fits all Mikuni carbs. Billet aluminum with all stainless hardware included.

Part Number: 01-02-557

The preferred choice for fuel filters and water separators. Fits all Yamaha Standups. Can be used also with KAWI and Polaris Octane models. 1/4" Inlet/Oulet hose size.

Part Number: 01-02-551

Fuel Jug Rack - Dual trailer mounted fuel canister holder. Includes all mounting hardware. Super clean and sanitary. Includes Lockable retention cable for security.

Part Number: 06-06-131

Allows air to flow in one direction. 1/4" Barbed ends. Available in clear/black only.

Part Number: 01-02-554

Reduced size 8.5 Liter (2.25 Gal) fuel tank. Less weight- required when using TNT, RRP or PowerFactor Pipes. Specially designed fuel tank incorporates lower baffle section to reduce fuel sloshing guaranteeing uninterrupted fuel supply. Comes equipped with Dual Fuel Pickups, Fuel Pickup Filters and Fuel Tank Fittings for Gas Tank Vent and Return Lines.

Blowsion Carbon composite tank holder keeps the tank from sliding around in the bottom of a hull during freestyle maneuvers. Available for Small Fuel Tank and OEM/ColdFusion Yamaha Fuel Tanks.

Inline Fuel Filter 1/4". Clear Plastic for High Volume, Low pressure Fuel Systems. Inline fuel filters filter out those harmful particles that can cause engine damage.

Part Number: 01-02-550

Universal Fuel Pickup Filter. Add some of these for extra fuel filtration and also keeps the fuel in your lines when going upside down.

Part Number: 01-02-449

Brand New OEM Yamaha Superjet Fuel Tank. Also fits most aftermarket hull applications using Yamaha based platform (Rickter, Krash, Tigercraft, ETC).

OEM Part Number: EW2-67711-01-00

Finish the look of your engine compartment with Blowsion specialty colored 1/8" fuel primer hose. Available in Clear, Blue, Green, Orange, Red, Yellow, or Black. Quantity is sold by the foot.

Finish the look of your engine compartment with Blowsion specialty colored 1/4" fuel hose. Available in Clear, Blue, Green, Orange, Red, Yellow, or Black. Quantity is sold by the foot in continuous lengths.

RRP Universal Rear Mounted Lo-Pro fuel cell. Fits all RICKTER model stand up watercraft. 5.85 liters (1.55 gallons) fuel capacity. Offset mounting allows for more inertia in triple lindy backflips! Includes Anodized Black Billet Filler and Fuel Cap.

Part Number: 01-02-571

Blowsion Fuel Tank Fitting with Rubber Grommet. 1/4 Hose Barb. Compression Fit. Install with 17/32 Drill Bit.

Part Number: 01-02-598