Search results for 'mat'

Rule Non-Automatic 500GPH Fully Submersible 12 Volt DC bilge pump. Unmatched in pumping power and longevity. Higher Flow – optimized impeller to provide greater flow at the same amperage. Back Flow Prevention - reduces the amount of water left over in the bilge, reducing odor and helping keep your bilge cleaner. Easy to mount and ready to go!

Part Number: 06-01-001

Introducing Long John Silver. Extended Length Bow Eye Bushing for those custom install rear mat kick wedges or thick tray undermat. One extra full inch of thread guarantees plenty of material to nut up to! Offered in Anodized Black and Clear.

Put this 0.5 ounce tube of miracle gel in your toolbox! This is the cure for for scattered spark resulting form moisture and corrosion of your spark plug ends and boots.

Part Number: 08798-0001

Add a kick tail to your watercraft bottom mat area with this 1" wedge. Helps to keep the riders back foot from slipping out of the tray and getting weight farther forward.

Part Number: 04-02-345

Hydro-Turf 40" x 62" Diamond Groove sheet material. Blowsion stocks all available colors and groove options listed. We are overflowing with turf!

See our special formulated solvent-based Mat Glue for Installation.

Hydro Turf 40" x 49" Waffle Groove sheet material. Blowsion stocks all available colors listed. We are overflowing with turf!

See our special formulated solvent-based Mat Glue for Installation.

The key to installing Tubbie Sponsons, Railcaps and other composite accessories on your watercraft. Easy-to-use tube fits a standard caulking gun. Fast-set formula dries tack-free in 90 minutes and delivers extremely tough bonds. Color: White.

Part Number: 06-03-135

48" x 17.5" section of 9mm thick plush (softer) foam undermat. This our softest underpad. PLUSH offers greater comfort and compression recovery for extreme riders.

Part Number: 04-02-328

48" x 17.5" section of 26mm thick plush (softer) foam undermat. This our softest underpad. PLUSH offers greater comfort and compression recovery for extreme riders.

Part Number: 04-02-330

48" x 17.5" section of 18mm thick plush (softer) foam undermat. This our softest underpad. PLUSH offers greater comfort and compression recovery for extreme riders.

Part Number: 04-02-331

Dual Color Sheets of 1/4" (5.5mm) Hydro-Turf with Cut Diamond Grooves. Available in any two of the color combinations Hydro Turf offers on the below drop down menus.

See our special formulated solvent-based Mat Glue for Installation.

Blowsion Adjustable T-Handle Factory Pipe Headpipe Water Screw Kit - Standard Size. T-Handle Design provides quick and easy adjustments for tuning. This kit is a direct replacement for those seized up water adjusting screws. Compatible with all Factory Headpipes.

Part Number: 01-01-741

Jet Dynamics Intake Grate #1 Deep. The Jet Dynamics Shaft Shielding Top loader design is unbeatable for all around performance. Fits all 1986-1995 Kawasaki 650SX, X2 and Jet Mate Models. JD#1-SST.

Part Number: 02-01-150

Rule 25SA Fully Submersible Bilge Pump, 500 Gallon Per Hour, 12 Volt DC, Automatic Electronic Sensing. Bilge Pump turns on and checks for water approximately every 2-1/2 minutes. If resistance (water) is found, it will run for as long as water is present. When all the water is pumped out, the pump shuts off and returns to its 2-1/2 minute test cycle.

Part Number: 06-01-002

Jet Renu “Purple” Wash and Wax is the ultimate high foaming premium soap which is fortified with 100% Brazilian Carnauba Wax. “Purple” cleans deep down into the gel coat and painted surface, lifts away caked on dirt and grime while leaving behind a high gloss shine and a protective barrier from the sun’s harmful UV rays. Our super concentrated formula is pH balanced, biodegradable and non-toxic. Size: 1 Gallon.

Part Number: JR-1002