Catalog Advanced Search

Why buy a bunch of confusing fiberglass materials to reinforce your ski when we can provide you with just the right amount. Pre cut tri-axial panels to reinforce both sides of your ski.

Part Number: 05-05-012

Why buy a bunch of confusing fiberglass materials to reinforce your ski when we can provide you with just the right amount. Pre cut tri-axial panels to reinforce both sides of your ski.

Part Number: 05-05-011

Each kit includes all materials needed for mixing into, and handling, your installation resin (available separately). Silica Thickener, Mixing Cups, Brushes, Gloves and Knitted fabric cloth for all seams.

Part Number: 06-03-113

An ultra bitchin' way to keep your rear edge tray mat wrapped and sealed down. Excellent solution to a problem area for all mat installations. Available for all models.

The key to installing Tubbie Sponsons, Railcaps and other composite accessories on your watercraft. Easy-to-use tube fits a standard caulking gun. Fast-set formula dries tack-free in 90 minutes and delivers extremely tough bonds. Color: Black.

Part Number: 06-03-136

The key to installing Tubbie Sponsons, Railcaps and other composite accessories on your watercraft. Easy-to-use tube fits a standard caulking gun. Fast-set formula dries tack-free in 90 minutes and delivers extremely tough bonds. Color: White.

Part Number: 06-03-135

Blowsion Mat Kit Glue "Blow Goo" to the rescue. Use this solvent-based contact adhesive with your Hydro Turf or stitched mat kit and never worry again about your mats coming loose. Not water-based!

Part Number: 06-03-141

Blowsion Mat Kit Glue "Blow Goo" to the rescue. Use this solvent-based contact adhesive with your Hydro Turf or stitched mat kit and never worry again about your mats coming loose. Not water-based!

Part Number: 06-03-142

Mikuni high and low-speed carburetor adjuster screws with "T" cross bar - extended length for easy adjustments. Absolutely a must when running aftermarket pipes.

Part Number: 01-02-540

Mikuni high and low-speed adjuster screws with "T" cross bar - extended length for easy adjustment. Absolutely a must when running aftermarket pipes. Fits all 1996-2020 Yamaha Superjet OEM 38mm Mikuni Carburetors.

Part Number: 01-02-544

Mikuni Diaphragm Mount throttle cable bracket. Trick mounting setups are enabled with this handy bracket. Stainless Steel Mounting Hardware Included. Now available in two sizes.

ODI Grip Blowsion Logo Lock Ring End Cap Combo- now you can have the anodized bling look all the way through to the end cap. Each kit includes inner lock rings, and outer lock ring/caps w/ hardware.

Oil block-off plates allow for an easy conversion from factory oil injection to pre-mixing your own fuel. Block-off plates fit all Yamaha 650701/760 and Kawasaki 650/750 Models. Hardware included. Anodized Black.

Part Number: 01-03-812

Seperate One Way valve assembly only. Great for secondary dump tubes.

Part Number: 06-01-020

Fits 8mm choke shaft Keihin dual carburetor. Starting the engine of your personal watercraft is never a problem with a Blowsion primer kit. All brass fittings and bulletproof plunger. Get rid of that worthless factory choke and apply a direct shot of fuel!

Part Number: 01-02-404