Primers & Fittings
-
Mikuni Adjusting T Screws - Kawasaki
Mikuni high and low-speed carburetor adjuster screws with "T" cross bar - extended length for easy adjustments. Absolutely a must when running aftermarket pipes.
Part Number: 01-02-540
Learn More -
Primer Kit - Mikuni Single
Fits 6mm choke shaft Mikuni single carburetor. Starting the engine of your personal watercraft is never a problem with a Blowsion primer kit.
Part Number: 01-02-401
Learn More -
Pulse Line Fitting 1/4"
Brass Press In Straight Pulse Line Nipple Fitting 1/4" Hose Barb. Use for dual carburetor setups with dual fuel pumps where a second pulse line is required.
Part Number: 01-02-530
Learn More -
Primer Bulb Kit - Keihin Dual
Fits 8mm choke shaft Keihin dual carburetor. Starting the engine of your personal watercraft is never a problem with a Blowsion primer kit. All brass fittings and Primer Bulb Get rid of that worthless factory choke and apply a direct shot of fuel! Pair with the Blowsion Dash Fitting for best protection.
Part Number: 01-02-408
Learn More -
Primer Kit - Keihin Single
Fits 8mm choke shaft Keihin single carburetors. Starting the engine of your personal watercraft is never a problem with a Blowsion primer kit. All brass fittings and bulletproof plunger. Get rid of that worthless factory choke and apply a direct shot of fuel!
Part Number: 01-02-403
Learn More -
Bilge Switch / Primer Mounting Plate
This cool universal anodized black aluminum mounting plate allows easy mounting of the rotary bilge switch as well as primer bulb on the dash. Specifically designed for the SXR but will work with other models. Inside mounting with the correct bulb style primer hole and rotary bilge switch ID means a sanitary install in minutes with no grinders or tubes of silicone needed.
Part Number: 04-06-002
Learn More -
Blowsion Fuel Tank Fitting
Blowsion Fuel Tank Fitting with Rubber Grommet. 1/4 Hose Barb. Compression Fit. Install with 17/32 Drill Bit.
Part Number: 01-02-598
Learn More -
Primer Bulb Kit - Mikuni Dual
Fits 6mm choke shaft Mikuni dual carburetors. Starting the engine of your personal watercraft is never a problem with a Blowsion primer kit. All brass fittings and Primer Bulb. Get rid of that worthless factory choke and apply a direct shot of fuel! Pair with the Blowsion Dash Fitting for best protection.
Part Number: 01-02-406
Learn More -
Oil Injection Block Off Plate
Oil block-off plates allow for an easy conversion from factory oil injection to pre-mixing your own fuel. Block-off plates fit all Yamaha 650701/760 and Kawasaki 650/750 Models. Hardware included. Anodized Black.
Part Number: 01-03-812
Learn More -
Primer Bulb
Try the sanitary "non foot destroying" rubber-based bulb type primer. In stock and ready to flow! Pair with the Blowsion Dash Fitting for best protection.
Part Number: 01-02-411
Learn More -
Blowsion Colored Hose - 1/8 inch
Finish the look of your engine compartment with Blowsion specialty colored 1/8" fuel primer hose. Available in Clear, Blue, Green, Orange, Red, Yellow, or Black. Quantity is sold by the foot.
Learn More