Bilge

Rule 25SA Fully Submersible Bilge Pump, 500 Gallon Per Hour, 12 Volt DC, Automatic Electronic Sensing. Bilge Pump turns on and checks for water approximately every 2-1/2 minutes. If resistance (water) is found, it will run for as long as water is present. When all the water is pumped out, the pump shuts off and returns to its 2-1/2 minute test cycle.

Part Number: 06-01-002

Replacement Fuel Resistant Rule Bilge Pump Strainer Base. Compatible with All Rule 360-1100GPH Models.

Part Number: 06-01-311

Rule Non-Automatic 500GPH Fully Submersible 12 Volt DC bilge pump. Unmatched in pumping power and longevity. Higher Flow – optimized impeller to provide greater flow at the same amperage. Back Flow Prevention - reduces the amount of water left over in the bilge, reducing odor and helping keep your bilge cleaner. Easy to mount and ready to go!

Part Number: 06-01-001

RRP Scupper Valve Replacement. Complete Assembly.

Part Number: 06-01-030

Replacement RRP Rickter Scupper Valve Rubber Flap Only.

Part Number: 06-01-031

Replacement OEM bullet connectors now available at Blowsion. Kit includes 5 Male and Female terminals with Insulators. Perfect for those super sanitary bilge kit installations or replacements for Electrical box connections.

Part Number: 01-04-417

The pro-finish kit, which allows for a completely sanitized rear outlet, (paint and finish work required).

Part Number: 06-01-028

Blowsion Bilge Pump Hose - 10 Foot Section is plenty for most dual pump and custom applications. Color: Black Only. Hose Diameter (ID): 3/4" inch.

Part Number: 06-01-302

Blowsion machined aluminum dash fittings are used to recess mount rotary bilge switches and/or primer bulbs in the dash of your ski. Available in Black, Blue, Red, Green, Orange, Clear, Purple and Teal colors.

Finally- a replacement switch and 9 feet of cable for the always popular handlebar mount switches.

Part Number: 06-01-215

Available for riders wanting to use the end flange only for custom scupper and rear exhaust installations etc. The new billet flange assembly is the premium design setup and allows use of the Blowsion billet exhaust outlet so vain riders can sanitize both sides of the rear of their watercraft. Fits all years Super Jet, KAWI 750 and SXR 800, KAWI 650, and Polaris Octane. Anodized Clear.

Part Number: 06-01-023

No more home insulation foam in a can. This is the real deal. Marine quality expanding foam. Mix equal parts A and B in the supplied mixing cups and you have waterproof and cured foam expanding in 60 seconds or less.

Part Number: 06-03-132

A simple installation drain valve alternative for the OEM drain plugs in 1992-2009 Seadoo, 2004-2024 Yamaha WaveRunner Sitdowns, 2002-2009 Honda Aquatrax and 1996-2002 Polaris model Watercraft See complete list below for model fitment. Available in Black or Clear. Sold Each.

NEW Blowsion Kawasaki Flanged Model. A simple installation drain valve alternative for the OEM drain plugs in Kawasaki model Watercraft. Color: Anodized Black. Sold Each.

Part Number: 06-01-068 Learn More

Dual bilge pump mounting bracket for Kawasaki Sxi Pro and KAWASAKI SXR 800. The bracket locates the pumps within millimeters from the base of the KAWI hull. Easy built in installation, no messy adhesives. Material: Aluminum. Color: Anodized Black.

Part Number: 06-01-101