Products

The Blowsion Destroyer Sponsons are built and shaped specific to the unique hull shape of the Kawasaki SXR, 750 and HydroSpace, the Tubbie Race Destroyer for the SXR and HS is fully removable with an average 10 minute per side install! Available with Black or White Finish.

Fuel Control Valve/Hose Assembly. Fits all upright style 5 gallon fuel jugs. Handy hose cap keeps moisture and debris from entering and contaminating fuel during transport or storage.

Part Number: 06-04-024

Why buy a bunch of confusing fiberglass materials to reinforce your ski when we can provide you with just the right amount. Pre cut tri-axial panels to reinforce both sides of your ski.

Part Number: 05-05-012

The pro-finish kit, which allows for a completely sanitized rear outlet, (paint and finish work required).

Part Number: 06-01-028

This cool universal anodized black aluminum mounting plate allows easy mounting of the rotary bilge switch as well as primer bulb on the dash. Specifically designed for the SXR but will work with other models. Inside mounting with the correct bulb style primer hole and rotary bilge switch ID means a sanitary install in minutes with no grinders or tubes of silicone needed.

Part Number: 04-06-002

Blowsion FlexFit One Ten Snapback Hat. Color: Black with White Logo.

Part Number: 07-01-854

Introducing Long John Silver. Extended Length Bow Eye Bushing for those custom install rear mat kick wedges or thick tray undermat. One extra full inch of thread guarantees plenty of material to nut up to! Offered in Anodized Black and Clear.

A simple installation drain valve alternative for the OEM drain plugs in Kawasaki model Watercraft. Available in Black, Clear and Green. Sold Each.

These hand-laid, molded fiberglass insets provide extended room in the tray of your ski to position your feet. Comfortably sized for average feet (sizes 6-11), these footwells also feature a gentle protrusion over the top of your foot.

Part Number: 05-03-004

316 Stainless Steel Heavy Duty T-Bolt Hose Clamp for 3.5" Exhaust Couplers. Compatible with all TNT, RRP Carbon and PowerFactor Style Exhaust Systems.

Part Number: 01-01-175

Mikuni Diaphragm Mount throttle cable bracket. Trick mounting setups are enabled with this handy bracket. Stainless Steel Mounting Hardware Included. Now available in two sizes.

Blowsion Engine Leak Down Block Off Kit. This is an essential tool for determining engine health. Make sure your fresh rebuilt engine is sealed properly, or use it to diagnose engine and/or tuning issues. Utilize your existing leak down tester or plug your Pop-off pressure gauge into the pulse fitting on your cases and check for air leaks. Includes anodized aluminum plates and rubber gaskets to match. All mounting hardware included. Fits all years 62T 701 engines and 62t 760 engines with a b-pipe manifold.

Part Number: 01-03-816

Blowsion Classic Snapback Hat. One Size Fits Most. Color: Black/Charcoal.

Part Number: 07-01-841

Blowsion 8mm Billet Conical Washers. Replace the brittle and breakable plastic nylon washers that are included with Rickter and many aftermarket hulls. Available in all Colors!

Fits 8mm choke shaft Keihin single carburetors. Starting the engine of your personal watercraft is never a problem with a Blowsion primer kit. All brass fittings and Primer Bulb. Get rid of that worthless factory choke and apply a direct shot of fuel! Pair with the Blowsion Dash Fitting for best protection.

Part Number: 01-02-407