Blowsion
Bilge Fitting 45-Degree
Bilge Fitting 45-Degree
SKU:04-03-031
In stock
Couldn't load pickup availability
Blowsion machined aluminum 45 Degree bilge fittings are a clean replacement of the bulky plastic fittings usually supplied with aftermarket bilge pump kits. Our fittings have a 3/4" Inch hose barb flange machined on them so no hose clamp is necessary. Offered in Anodized Clear and Black.
- Hose Barb Diameter (OD): 3/4" Inch
- Thread Length: 1/2" Inch
- Nut Width: 1-1/4" Inch
- NOTE: Install with 1" Inch Hole Saw Bit.
Color Options
- PN# 04-03-031 - Anodized Black
- PN# 04-03-038 - Anodized Clear
Liability Disclaimer – Closed Course Use Only
Liability Disclaimer – Closed Course Use Only
Blowsion products are intended for closed course competition use only. These products are not designed, tested, or approved for use on public waterways or pollution-controlled vehicles.
Installation and operation of Blowsion components may affect the safety, emissions compliance, and legal status of your watercraft. Use of these products on public waterways may be a violation of federal, state, or local laws.
By purchasing and installing Blowsion products, the user assumes all responsibility and risk associated with their use, including but not limited to personal injury, property damage, or legal penalties.
Always follow proper safety procedures and consult with a qualified technician for installation.
Product Installation Disclaimer:
Warning:
When using electric or battery-operated tools inside the hull, ensure the area is well-ventilated and free of fumes. Failure to follow this precaution may result in fire, explosion, serious injury, or death.
Disconnect the battery before performing any installation or maintenance to prevent accidental ignition or electrical shock.
Allow the engine to cool completely before beginning installation.
No Smoking!
This kit is not designed for use on vehicles equipped with pollution control systems. Installing this kit on such vehicles may violate state or local laws
Share
