Hull Components

The RRP Adjustable Hood Latch is made from billet aluminium 6061 t6. This adjustable hood latch gives you the possibility to adjust the amount of pressure applied on the hood seal in a second. Extremely strong design eliminating failure of the latch and danger of losing hood and the ability of sinking the ski. Available in Red, Black, Blue, Green.

The New Rickter-RRP Hood Latch has been produced for use on all, Rickter standup hulls, Rickter MX1, Yamaha Superjets and any aftermarket hulls using Yamaha based latch systems. This new complete latch features the Rickter-RRP adjustable hood latch allowing you to easily adjust the pressure applied on the hood seal preventing water intrusion. The adjustable hood latch comes complete with all the hardware needed for installation. Available in 2 anodized colors.

RRP Rickter Ninja Carbon Hood Air Scoop

Part Number: 04-04-408

RRP Rickter Ninja TeXtreme Carbon FIber Hood Air Scoop.

Part Number: 04-04-400

Replacement RRP Rickter Adjustable Engine Plates for all Rickter Hulls. Anodized Black.

Part Number: 01-03-245

Replacement RRP Rickter Adjustable Footwell Binding Bracket Plates for Yamaha Superjet. Set Includes Left and Right Side. Anodized Black.

Part Number: 05-03-026

Replacement RRP Rickter Adjustable Footwell Bracket Plates for 2015 and Newer Rickter XFS and XFR Hull Models. Set Includes Left and Right Side. Anodized Black.

Part Number: 05-03-027

The RRP Rickter Front Foothold is wrapped with two layers of 9mm premium plush underpad with Rickter’s durable yet soft molded diamond Hydro-Turf EVA. Also includes install hardware of 4 x M8 Countersunk bolts, Washers, Locknuts, and RRP AB Washers for a clean and strong installation. The EVA is wider on the sides of the binding to accommodate a range of tray sizes. Light trimming of the EVA Is recommended for the ideal fit followed by drilling four holes in the dash to install the binding at the desired height.

Part Number: 05-03-019

RRP Rickter Adjustable Hood Prongs. Machined from billet aluminum with stainless steel pins. Adjustable in their mounting position so you can dial in that hood seal pressure. Fits 1996 and Newer Yamaha Superjets, Rickters, and other aftermarket hulls. Available in anodized Black. Sold as Pair (2)

Part Number: 04-04-377

Replacement RRP Rickter Hood Seal. Fits all Rickter Stand up Hull Models.

Part Number: 04-04-409

Replacement RRP Rickter Hood Seal. Fits all Rickter MX1 Hull Models.

Part Number: 04-04-410

RRP Scupper Valve Replacement. Complete Assembly.

Part Number: 06-01-030