Engine Performance

Finish the look of your engine compartment with Blowsion specialty colored 3/8" water cooling hose. Available in Clear, Blue, Green, Orange, Red, Yellow, or Black. Quantity is sold by the foot in continuous lengths.

Blowsion Stainless Steel Socket Head Bolt Kit for Mikuni Super BN Carburetors. The Socket Head Bolt design allows for use of hex key tool which results in much easier access. Replace those easy to strip Mikuni phillips head screws before it is too late!

Part Number: 01-02-547

Blowsion Exhaust Water Injector Brass Fitting. Tapped and threaded for a Mikuni Main Jet. 1/4" Hose Barb x 1/8" NPT. Bidirectionally slotted for better cooling. Used on aftermarket high performance exhaust systems (TNT/Powerfactor/RRP).

Part Number: 01-01-075

Motion Pro Fuel Shut-Off Valve 1/4" Separating Quick Connect (MP#12-0029).

Heavy Duty Stainless Steel Hose Clamp. Compatible with all 2.0" to 2.75" Inch (OD) Exhaust Couplers. Sold Each.

Part Number: 01-01-176

The 1/4" Quick Disconnect / Fuel Restrictor can be used as fuel line quick disconnect and/or for fuel restriction. Pre-tapped and threaded to accept Mikuni Main Jet (Jets not included). Includes stainless steel hose clamps. Now Available in all colors!

Aftermarket Keihin Carburetor Rebuild Kit for 38mm, 40mm, 42mm and 44mm CDK-II Carburetors. Fits wide range of 38-44mm Keihin™ CDK-II carbs found on PWC. Includes Viton™ tipped inlet needle.

Part Number: 01-02-492

VK Composites Carbon Fiber B-Pipe Exhaust Chamber (Limited). Full Carbon with High Temp Epoxy Resin. Brass Water Injection Insert Included.

Part Number: 01-01-366

Finish the look of your engine compartment with Blowsion specialty colored 1/8" fuel primer hose. Available in Clear, Blue, Green, Orange, Red, Yellow, or Black. Quantity is sold by the foot.

S.E - Speedmagic 50mm Ninja Dual Carburetors. 50mm dual carb set straight out of Japan (Sato Engineering). These carbs will support a wide range of applications and are perfect for big-bore motors 900cc plus.

Part Number: 01-02-106

3.5 Inch Heavy Duty 6 Ply Exhaust Coupler for TNT V2/V3 and PowerFactor Exhaust Systems. Connects Exhaust Manifold to Chamber.

Part Number: 01-01-167

1/8 NPT x 3/8 Barb 90-Degree Brass Elbow Fitting. Used on Most 2-Stroke PWC.

Part Number: 01-01-076

3/8" x 1/4" x 3/8" Barbed Reducer T Hose Fitting. Useful for different types of water routing applications. Primarily used with Water Injection. Color: Black

Part Number: 01-01-070

The 3/8" Quick Disconnect / Water Restrictor can be used as Quick Disconnect or use one of 3 supplied brass inserts to restrict the flow of water or increase pressure where it is needed. Includes 3 brass restrictors and stainless steel hose clamps. Now Available in all colors!

Blowsion Adjustable SHCS Factory Pipe Headpipe Water Screw Kit - Standard Size. Socket Head Cap Screw Design provides adjustments for tuning. This kit is a direct replacement for those seized up water adjusting screws. Compatible with all Factory Headpipes. Kit Includes 3 screws, 3 nuts and hex key.

Part Number: 01-01-743